uivehicle’s multi way bed kit is easy to install. Customers can easily complete the installation by removing the tie down hooks, and then securing the bed frame with supplied bolts.
It is set up with a height adjustable bed frame made of stainless steel, coming in two variants of Low and High.
Low can be adjusted to 5 different height levels: 240mm, 280mm, 320mm, 360mm, 400mm.
High can be adjusted to 6 different height levels: 290mm, 330mm, 370mm, 410mm, 450mm, 490mm.
Low with 240mm height allows the bed mat to be installed right above the spare tire compartment to maximize the space above bed.
[Standard body 5-seater Hiaces (Dimension: 4695x1695x1980mm) would have approximately 1020mm space between bed mats to ceiling.]
Color or cushion thickness etc. are able to be customized based on customer preference, such customizations are accepted at additional charges.
Each bed kit comes with a serial number.
The bed is full flat with length of 2310mm.
The frames that are supporting the bed mats behind second row seat are adjustable, adapting to height adjustment depended on the pieces of the bed mats.
For H200 standard body 5-seater vehicles. Leather&20mm urethane (black)
The bed is full flat.
It is available to fold right and left for standard body Hiaces.
(※ Can’t be used in the Hiaces released between 2012.5~2013.11 and in the Hiaces with rear seat belts equipped.)
Shows the case when the second row seat fold up
・This is the most used choice that folding up the second row seat and flat the bed.
・It is able to store a 20L polytank under the bed.
・Shows the case when the second row seat fold down.
・When the second row seat is needed to fold up, remove the third bed mat from the front.
・Upper second row seat is flat with the bed.
・Here is the point.
・It is available to fold 2 bed mats left while one right. In this case, please adjust the height of frame to be more than 410mm, however, please also note that it may be not stable when driving.
(※ Can’t be used in the Hiaces released between 2012.5~2013.11 and in the Hiaces with rear seat belts equipped.)
Shows the case when the second row seat fold down.
As you can see, as the bed frames are adjustable, enable the seat be full flat.
・Additionally, it is easy to adjust or level the frame height with bolts & nuts, which come with a knob.
When lower the frame height shown, maximum space ABOVE bed can be used !
・Electroplating plating finished on the frame.
・Easy to install with 4 bolts.
Easy to adjust or level the frame height with bolts & nuts, which come with a knob.
・When raise the frame height shown, maximum space UNDER bed can be used !
・Polytank, cooler box etc. can be easily stored.
The bed frame supporting the bed mat right behind the second row seat can be slid into the rear main frame so as to make it possible to install a sliding rail and fold down the second row seat.
※The frame has been changed from square material to round material from 2014.1.